Aurora AU1235XA User Manual download pdf (Page 3)

4 ENGLISH 5ENGLISH

OPERATION



ControlSwitch

 Using the switch located on the unit, select one of the following settings by sliding the switch either left

or right. (FIGURE 2)

I AUTO/ON:

This setting allows the shredder to be automatically started by insert-

ing paper into the feed slot. Always feed the paper in as straight

as possible. When the paper has passed through, the shredder will

automatically stop.

READY:The green LED light indicates the shredder in “On” and

ready for use.

O OFF:

This setting turns off all features of the shredder. For safety reasons,

we recommend that you leave the shredder in the “Off” position

whenever the shredder is unattended or not in use.

R REV(REVERSE):

In the unlikely event of a paper jam, the reverse setting can be used

to help clear the cutters of paper that did not pass through. Never

attempt to clear a jam by using the reverse function until you have

emptied the wastebasket.

CONTINUED NEXT PAGE

INSTALLATION

PaperShredder

OperatingInstructions

Installation

Operation

Maintenance

Troubleshooting

Service Center

Limited Warranty

*ONEFOLDEDSHEETOFPAPEREQUATESTO2SHEETSOFPAPER

Heavier paper, humidity or other than rated voltage may reduce shredding capacity.

Sheet Capacity

Paper Shred Size

Paper Entry Width

Credit Card Capacity

Duty Cycle

Voltage

12 Sheets of 20 lb. bond paper*

0.20in. x 2.17 in. pieces

5 mm x 55 mm pieces

8.7 in / 220 mm

1 at a time

5 min. on / 30 min. off

120V~60Hz / 3.0 A

FIGURE2







Caution:

1. Make sure the basket door is securely closed shut. This shredder features a safety power cut off and

will not operate if door is open. Shredders with pull-out wastebaskets feature a safety power cut off

upon bin removal. The supplied wastebasket activates this switch, which allows the shredder to be

operable. (FIGURE 1)

2. Attach all 4 caster wheels to the bottom of the wastebasket.

3. A socket-outlet should be near the equipment and be easily accessible.

4. Connect the power cord to any standard 120 volt AC outlet.

Crosscut shredders have very sharp exposed blades on the underside.

Use care when mounting the shredder on the wastebasket.

FIGURE1

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Aurora AU1235XA User Manual Page 3

Comments to this Manuals