11
APPENDIX 1 Troubleshooting
1. LED is not lit on any LEDs or
buttons
a. Check 12v power supply is plugged in rear of unit
b. Check to see if Wall supply is plugged into wall outlet.
c. Make certain wall outlet has power.
d. Make certain switch on rear of unit is on.
a. Check connection on RS-232 port. Make certain TX goes to RX and
RX goes to TX of the device to be connected. Don’t forget about
ground.
b. Check baud rate.
c. Verify commands being sent are correct protocol.
3. Some functions do not work
a. Make certain unit has latest firmware.
Comments to this Manuals